User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
18
3.2 Wireless LAN Network Creation
The network manager can configure related wireless settings, General Settings, Advanced Settings, Virtual AP(VAP)
Setting, Security Settings and MAC Filter Settings.
3.2.1 Wireless General Setup
The administrator can change the data transmission, channel and output power settings for the system. Please click on
Wireless -> General Setup and follow the below setting.
 MAC Address : The MAC address of the Wireless interface is displayed here.
 Band Mode : Select an appropriate wireless band; bands available are 801.11a or 802.11a/n mixed mode.
 AP Isolation : Select Enable, all clients will be isolated from each VAP, that means different VAP's clients can not
reach to each other.
 Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from 6 to
54Mbps only for 802.11a mode.
 Country : US.
 Channel/Frequency : The channel range will be changed by selecting different country code. Below depicts the
channel range for different Country. When “Band Mode” selected in “802.11a/n”, the Channel 165 does not shown-
up on list.
Country Channel
US 36, 40, 44, 48, 52, 56, 60, 64, 149, 153, 157, 161, 165
 Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless network.
Specify digit numbers between 1 to 100 (the unit is %) for your environment. If you are not sure which setting to
choose, then keep the default setting, 100%.
When Band Mode select in 802.11a only mode, the HT(High Throughput) settings should be hidden immediately.