User's Manual
User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
16
3.1.2 Configure LAN IP
Here are the instructions to setup the local IP Address and Netmask.
Please click on System -> LAN and follow the below setting.
Mode : Check either “Static IP” or “Dynamic IP” button as desired to set up the system IP of LAN port .
Static IP : The administrator can manually setup the LAN IP address when static IP is available/ preferred.
IP Address : The IP address of the LAN port; default IP address is 192.168.2.254
IP Netmask : The Subnet mask of the LAN port; default Netmask is 255.255.255.0
IP Gateway : The default gateway of the LAN port; default Gateway is 192.168.2.1
Dynamic IP : This configuration type is applicable when the WCB1200H5PX is connected to a network with the
presence of a DHCP server; all related IP information will be provided by the DHCP server automatically.
Hostname : The Hostname of the LAN port
DNS : Check either “No Default DNS Server” or “Specify DNS Server IP” button as desired to set up the system DNS.
Primary : The IP address of the primary DNS server.
Secondary : The IP address of the secondary DNS server.
802.1d Spanning Tree
The spanning tree network protocol provides a loop free topology for a bridged LAN between LAN interface and 4
WDS interfaces from wds0 to wds3. The Spanning Tree Protocol, which is also referred to as STP, is defined in the
IEEE Standard 802.1d. The Spanning tree always enabled on WCB1200H5PX. Below Figures depict a loop for a
bridged LAN between LAN and WDS link