User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
8
1.5 Specification
 Wireless Architecture Mode
 Router AP Mode
 Wire connection as WAN , in this mode , the device run as DHCP server to assign IP address to wireless
clients out of a private IP address pool behind a NAT
 This enables the wireless interconnection of Access Point in an IEEE802.11 network .and accept wireless
clients at the same time
 AP Mode
 Pure AP Mode
• It can be deployed as a tradition fixed wireless Access Point
• It allow wireless clients or Stations(STA ) to access
 AP/WDS Mode
• This enables the wireless interconnection of Access Point in an IEEE802.11 network .and accept
wireless clients at the same time
 WDS Mode
 This enables the wireless interconnection of Access Point in an IEEE802.11 network.
 It allows a wireless network to be expanded using multiple access point without the need for a wired
backbone to link them.
 This also be referred to as repeater mode.
 It can’t allow wireless clients or Stations (STA) to associate.
 CPE Mode
 WiFi connection as WAN , in CPE mode , the device run as DHCP server to assign IP address to wire clients
out of a private IP address pool behind a NAT
 Client Bridge(CB) + Universal Repeater(UR) Mode
 A wireless repeater and bridge with DHCP server enabled, clients on the same subnet as host AP(Primary
Router).
 CPE + AP Mode
 WiFi connection as WAN , in this mode , the device run as DHCP server to assign IP address to wire and
wireless clients out of a private IP address pool behind a NAT
 Networking
 Support Static IP, Dynamic IP(DHCP Client), PPPoE and PPTP on WAN Connection
 Support MPPE-64 and MPPE-128 Encryption on PPTP Connection
 Support PPTP/L2TP/IP Sec Pass Through
 PPPoE and PPTP Reconnect – Always On , On demand, Manual
 MAC Cloning