User's Manual

User Manual
WCB1000H5PX/WCB1010H5PX IEEE802.11bg High Power BS/Bridge/CPE
90
6.2.1 General Setup
The administrator can change the data transmission, channel and output power settings for the system. Please
click on Wireless -> General Setup and follow the below setting.









 ESSID : Assign Service Set ID for the wireless system.
 Band Mode : Select an appropriate wireless band; bands available are 801.11b, 802.11g and
802.11b+802.11g.
 Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from
1 to 54Mbps for 802.11g and 802.11b/g modes, or 1 to 11Mbps for 802.11b mode.
 Country : Select the desired country code from the drop-down list; the options are US, ETSI and Japan.
 Channel : The channel range will be changed by selecting different country code. The channel range from 1 to
11 for US country code, or 1 to 13 for ETSI country code, or 1 to 14 for Japan.
 Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless
network. Select the LEVEL 1 to LEVEL 9 you needed for your environment. If you are not sure of which
setting to choose, then keep the default setting, LEVEL 9.
 Security Type : Select the desired security type from the drop-down list; the options are WEP, WPA-PSK and
WPA2-PSK.
 Disable : Data are unencrypted during transmission when this option is selected.
 WEP : WEP, Wired Equivalent Privacy, is a data encryption mechanism based on a 64-bits , 128-bits or
152-bits shared key algorithm. Select WEP as the security type from drop-down list as desired. The WEP
key configured here must be exactly the same as the key on the base station that this system is
associated with.