User's Manual

EW-7301APg/EW-7302APg
User Manual
77
Site Survey
If Universal Repeater function is enabled, Site Survey tool is enabled to scan surrounding available APs. The system
manager can then select an appropriate/desired AP to be connected to extend its wireless service coverage.
Figure 5-2-6-1: Site Survey- when repeater function is disabled.
Figure 5-2-6-2: Site Survey- when repeater function is enabled.
• SSID: Service Set ID of the AP found around the system.
• MAC Address: MAC address of the respected AP.
• Channel: The channel number currently used by the respective AP.
• Rate: The transmitting rate of the respected AP.
• Signal: The signal strength of the respected AP.
• Security: Security type enabled by the respected AP.
• Setup/ Connect:
¾ Connect: If security type is none, click Connect to associate with the respected AP; no further configuration
is required.
¾ Setup: If security type is present, click Setup to configure settings to associate with the respected AP.
o WEP: Click Setup to configure the WEP setting required by to-be-associated target AP.
The following interface will then appear at the bottom of the screen and please provide the same settings
from to-be-associated target AP.