User's Manual

EW-7301APg/EW-7302APg
User Manual
74
Repeater Settings
The system can serve as an Access Point, a Repeater, or an Access Point with Repeater depending on deployment
needs. Select the desired mode from the drop down list, Repeater Type, and proceed with respected settings.
• None: When None is selected, the system is acting as an Access Point only; therefore, no further setting on the
Repeater tab is required.
• WDS: When WDS is selected, the system is acting as an Access Point with WDS Repeater.
¾ MAC: Enter the MAC address of the WDS peer. Click Add to add it into the list.
¾ MAC Address: Indicate the MAC address of the WDS peer.
¾ Enable: Check Enable button to activate the respected WDS link.
¾ Delete: Check Delete button, and click Delete to remove the respected WDS peer from the list.
¾ Security Type: Configure an appropriate security type for the WDS link, either None or WEP; the type
needs to be the same as that configured on WDS peer.
o WEP Key Length: Select the key length required from the drop down list, either 64 bits or 128 bits.
o WEP Key Format: Select the key format required from the drop down list, either ASCII or Hex format.
o WEP Key: Provide the WEP key value. The key value should follow the selected Key Format.
• Universal Repeater: Please provide the SSID of upper-bound AP and select security type (None, WEP, or WPA-
PSK). Site-survey tool will assist in this regard to provide necessary information.