User's Manual

EW-7301APg/EW-7302APg
User Manual
39
Site Survey
Access points located around the system can be found via the scan function. The administrator can then select a
desired AP to be associated with via this page.
Figure 4-2-4-1: AP Scan Result
• SSID: Service Set ID of the AP or repeater found around the system.
• MAC Address: MAC address of the respected AP or repeater.
• Channel: The channel number currently used by the respective AP or repeater.
• Rate: The transmitting rate of the respected AP or repeater.
• Signal: The signal strength of the respected AP or repeater.
• Security: Security type enabled by the respected AP or repeater.
• Setup/ Connect:
¾ Connect: Click Connect to associate with the respected AP directly; no further configuration is required.
¾ Setup: Click Setup to configure settings for associating with the respected AP or repeater.
o WEP: Click Setup to configure the WEP setting required by to-be-associated target AP.
The following interface appears at the bottom of the screen. For more information on the WEP
security settings, please refer to Section 4.2.3- Security Settings.