User's Manual

© 2008 4IPNET, INC.
18
4ipnet EAP100 User’s Manual
To extend its wireless coverage, EAP100’s WDS capability is capable of creating WDS links for connecting to other
WDS-capable APs (peer APs). EAP100 s upports up to 4 WDS links. By default, all WDS profiles are disabled.
 Click on the WDS button.
 Select the WDS Configuration tab.
 Select WDS link parameters:
(a) Choose one WDS Profile
(b) Enable WDS
(c) Enter MAC Address of Remote AP (peer AP)
(d) Select preferred Security Type
 To configure peer AP(s):
After completing the WDS s ettings at this EAP100 ( functioning as a “primary WDS station”), you must also
configure the settings of its peer AP(s).
If you use another EAP100 as the peer AP, simply repeat the above-mentioned s teps with the MAC Address
of the primary WDS station for setting WD S link parameters of the peer AP(s).
Step 5 (CONT). Check WDS Link Status
 Click on the Status button.
 Select the WDS List tab.
 Check the s ignal strength of WDS link(s)
Κ
Upon the co mpletion of Step 4, there shall be SNR displayedontheWDS Link Overview p age. If the SNR
is shown as N/A, check if the wiring is properly connected and please ensure the accurate execution of Step
4 as des cribed above.
Congratulation!
Now, 4ipnet EAP100 is inst alled and configured successfully.
• It is strongly recommended to make a backup copy of configuration settings.
• After EAP100's network configuration is completed, please remember to change the IP Address of your
PC Connection Properties back to its original settings in order to ensure that your PC functions properly
in its real network environments.