User's Manual

20
Set Encryption to Open System/Shared Key
WEP auth method: Select Open System and Shared Key to communicate
the key across the network.
WEP mode: Select 64, 128 bits.
Key Type: 64 bit support WEP password 10 bit HEX(Hexadecimal digits consist
or the numbers 0-9 and the letters A-F) code. 128 bit support WEP password 26
bit HEX code.( Note :Currently version does not support ASIC code.)
Valid Key: Select one of the keys in the Key table to be the active key.
Key Table: Enter up to four encryption keys here
Set Encryption to WPA-PSK
Authentication: WEP auth method select dis then select WPA and check
WPA-PSK
PSK: Enter a passphrase that will be shared by all devices using WPA-PSK on
the network.
Set Encryption to WPA-Enterprise(802.1x)
Authentication: WEP auth method select dis then select WPA and
WPA-Enterprise (802.1x)
RADIUS Server: Enter the IP address of the RADIUS server.
Authentic Port: 1812 is the port number dedicated to the authentication
function of the RADIUS server.
Accounting: Enter the IP address of the RADIUS server and port number
dedicated to RADIUS accounting. The RADIUS server uses accounting to
keep track of user login sessions.
Radius Key: Enter the secret Key that is required of all devices to
communicate with the RADIUS server.
(Note: If you change any item, click “submit” to store the value. Or click “clear” to
restore previous value. To make settings working click Submit-> Reset->
Restart.)