User's Manual
Administrator’s Manual
54
Figure 5-29
Wireless Port Configuration (2)
IP PNP: At the user end, you can use any IP address to connect to the machine at the
Wireless Port section; no matter what the IP address at the user end is, you can obtain
the Wireless Port and access the network resources properly, suppose you used static
IP address and specified IP address, Subnet Mask, Default Gateway and DNS.
User Authentication: You can choose to Enable or Disable user Wireless Port.
Operation Mode: It provides one modes: NAT Mode.
NAT Mode:All IP addresses externally connected through the Wireless Port
(these IP address must belong to the same subnet as the Wireless Port) will be
converted into the IP address of the WAN Port and connected to the outside
network.
IP Address: Enter your desired IP address for setup.
Subnet Mask: Enter your desired Subnet Mask for setup.
Related Setup for DHCP Server of Wireless Port. DHCP Server has two choices:
Disable DHCP Server and Enable DHCP Server.
1. Disable DHCP Server: Disable the function of the DHCP Server.