User's Manual
Administrator’s Manual
33
Configuration, Authentication Configuration, and Private LAN Configuration.
Please refer to the explicit setup if you need more information.
5.1.1. Configuration Wizard
The Wizard will guide you through the setup. All you need is to follow the procedures
and instructions given by the Wizard, step by step, fill in the required set values. And,
then restart to activate the setting.
Please click the “Run Wizard” button on the Setup Wizard interface as shown in
Figure 5-1 to start the system setup.
Figure 5-1 Setup Wizard Interface
The Setup Wizard Interface as shown in Figure 5-2 describes the installation
procedure, and there are 8 procedures as listed below:
1. Change Admin Password
2. Choose System’s Time Zone
3. Set System Information
4. Select the Connection Type for WAN Port
5. Configure Public Port’s Information
6. Set Wireless – Access Point Connection
7. Configure Wireless Port’s Information
8. Restart