User's Manual

Administrator’s Manual
30
4. Display the routing table: The internal routing table is displayed to assist the
confirmation of successful setup of another Static Route.
5. Display ARP table: The internal ARP table is displayed.
6. Display system live time: The system live time (time for system being turn on) is
displayed.
7. Check service status: The current execution status of each service is checked.
8. Set device into “safe mode”: If administrator is unable to use Web Management
Interface on the browser while device unexplicitly fails. Administrator can choose
this utility and set into safe mode, then administrator can management this device
with browser again.
9. Synchronize clock with NTP server: Immediately check and correct the clock
through the NTP protocol and network time server. Since the device does not
support manual setup for its internal clock, therefore we must reset the internal
clock through the NTP.
4.3. Change admin password
Besides supporting the use of console management interface through the connection
of null modem, the device also supports the SSH online connection for the setup.
When using a null modem to connect to the console, we do not need to enter
administrator’s password to enter the console management interface.
When SSH is used to connect the device, the username is “admin” and the default
password is also “admin”. This set is the same as those for the Web management
interface. You can use this option to change the administrator’s password. Even if
you forgot the password and are unable to login the console management interface