User's Manual

Administrator’s Manual

Warning: Public LAN cannot connect to Layer 3 device.

5. Connect the Private LAN port.

The Private LAN port is used to connect the trustful network or Ethernet. In other

words, the computer connected on Private LAN does not require login to use the

network resources. This port can be used to connect to a server such as File Server

or a DataBase Server, etc. Use the network cable of the 10/100BaseT to connect to

the Switch or Hub of the Private LAN, and then use the network cable of the

10/100BaseT to connect to the Administrator’s PC. If it is necessary to connect the

PC or wireless AP directly to the Private LAN, then we need to use the cross over line.

6. Turn on the power.

Plug the bundled power supply connector into the socket.

7. Check the LED indication light.

After the power is on, the power indication light should be lit. The WAN and indication

lights should be lit when the WAN and ports are properly connected to the network

equipment. The corresponding indication lights also should be lit when the Public LAN

and Private LAN ports are properly connected.

3.1.3. Setting up the PC for the Public LAN and Private

LAN

After the installation, the following must be set up for the Public LAN and Private LAN

sections:

 TCP/IP Network Setup

 Internet Connection Setup

3.1.3.1. TCP/IP Network Setup

 If the operating system of your PC is Windows 95/98/ME/2000/XP, then you just