User's Manual

Administrator’s Manual
10
3. Installation
3.1. Installation
3.1.1. System Requirements
 Standard 10/100BaseT including four network cables with RJ-45 connectors.
 All PCs need to install the TCP/IP network protocol.
3.1.2. Installation Procedure
Follow the following steps to install the system:
1. Make sure the power is turned off.
2. Connect the WAN port.
Use the network cable of the 10/100BaseT to connect to the system and the network
not managed, such as the ATU-Router of ADSL, port of Cable Modem, or the Switch or
Hub on the LAN of a company.
3. Connect the port. (Optional)
Use the network cable of the 10/100BaseT to connect to the system and the network
not managed, such as the ATU-Router of ADSL, port of Cable Modem, or the Switch or
Hub on the LAN of a company.
4. Connect the Public LAN.
The Public LAN is used to connect the desired network for management or WLAN,
and all users connected to the Public LAN must login successfully before using the
network resources. Use the network cable of the 10/100BaseT to connect to the
Switch or Hub of the Public LAN, and then use the network cable of the 10/100BaseT
to connect to the Administrator’s PC. If it is necessary to connect the PC or wireless
AP directly to the Public LAN, then we need to use the cross over line.