User's Manual

3.1.3 Point-to-Point (P2P) Mode
Two 5-into-1 devices, each in Point-to-Point (P2P) Mode, establish a wireless connection
between two wired networks, as shown in Figure 5. The two 5-into-1 devices operating in P2P
Mode do not allow client associations.
To configure the 5-into-1 devices to establish a P2P wireless bridge, ensure the following:
1. Enter the MAC address of P2P-2 device in the P2P MAC address field in the P2P-1 device.
2. Enter the MAC address of P2P-1 device in the P2P MAC address field in the P2P-2 device.