User's Manual

10. Client Mode Setup
10.1 Basic Setup
To configure the 5-into-1 in Client Mode, select Client from the Mode page (Figure 9), allow the
board to reboot, and click the Client: Setup button. Figure 21 and Table 20 describe the Client
Mode setup options.
Figure 21: Client Bridge Setup
Table 20: AP Setup
Field Description
Station Mode Selects 802.11g/b mode: 802.11b only or 802.11g/b
MAC Cloning
Mode
Enable MAC Cloning Mode. This clones all the MAC addresses of
devices connected to the Ethernet (wired) port to a single MAC
address sent out wirelessly to an AP or Repeater
SSID Wireless Network Name. You can enter it directly in this field or
click the Site Survey button to select from a list of available
networks.