User's Manual

9. Point-to-Multipoint (PMP) Setup
9.1 Basic Setup
To configure the 5-into-1 in PMP Mode, select PMP from the Mode page (Figure 9), allow the
board to reboot, and click the PMP: Setup button. Figure 20 and Table 17 describe the PMP
Mode setup options.
To set up the PMP bridge, the user must enter the MAC address(es) of the P2P bridge(s) to be
connected to this PMP bridge in the AP MAC Address field(s) of the PMP Mode setup page.
Up to six MAC addresses can be entered.
Figure 20: PMP Setup
Table 17: PMP Setup
Field Description
Remote AP
Connection Mode
Default is Static.
AP MAC Address
(1-6)
MAC address(es) of the P2P bridges that are connected
to this PMP bridge