User's Manual

8. Point-to-Point (P2P) Setup
8.1 Basic Setup
To configure the 5-into-1 in P2P Mode, select P2P from the Mode page (Figure 9), allow the
board to reboot, and click the P2P: Setup button. Figure 19 and Table 14 describe the P2P
Mode setup options.
To set up the P2P bridge, the user must enter the MAC address of the other P2P bridge to be
connected to this P2P bridge in the AP MAC Address field of the P2P Mode setup page.
Figure 19: P2P Setup
Table 14: P2P Setup
Field Description
AP MAC
Address
MAC address of the P2P bridge that this bridge is
connected to
Mode
Selects 802.11g/b mode: 802.11g only, 802.11b
only, or Mixed
Channel Selects the channel