User's Manual

SSID Wireless Network Name.
AutoLink
Enable/disable the AutoLink feature.
When AutoLink is enabled, the configuration utility automatically
patches the MAC Address to the SSID. This enables the client card
to generate a profile of the AP connected to with AutoLink. To
change the SSID, uncheck the AutoLink radio button and change
the SSID. Then, recheck the AutoLink radio button to continue.
Broadcast SSID Enable/disable the SSID broadcast feature.
Security Select Disable, WEP, or WPA security.
Select the option, and click the Setup button to enter the key(s) for
WEP or WPA.
Advanced Settings Click Setup to configure advanced settings.
Access Filter Click Setup to configure the access filter
7.3 Security Setup
To enable security, select the desired security mode (WEP or WPA) from the Repeater Mode
setup page (Figure 16) and click the Setup button to enter the keys. The following tables
describe the security setup options in more detail.
Table 10: WEP Setup
Field Description
WEP Length Selects the WEP key length: 64 bits or 128 bits.
Mode Selects the WEP key format, ASCII or Hex
Passphrase Passphrase used to generate the WEP keys.
Click the Generate button to generate the keys.
Click the Clear button to clear the Passphrase field.
Key 1-4 WEP keys
Default Tx key Selects the default WEP key (1-4)
Table 11: WPA Setup
Field Description
Authentication
Method
Select PSK mode
Passphrase WPA key
Group Re-Key
Time
Group Re-Key interval (seconds)
7.4 Advanced Settings
Access the Advanced Settings page by clicking the Advanced Settings: Setup button from the
Repeater Mode setup page (Figure 16). The Advanced Settings page allows the user to