User's Manual

1.0 Introduction
This document is the user manual for the 5-into-1 High Gain Wireless-G Mini Access Point
product.
1. Quick Start
The default IP address of the 5-in-1 is 192.168.0.10. The login is “admin” and password is
“password”.
1. Connect an antenna to the SMA connector closer to the LEDs. Note that there are two SMA
connectors on the board. The SMA connector closer to the LEDs is required. It is optional to
connect an antenna to the other connector
2. Connect the 5-into-1 to a PC using an ethernet cable.
3. Plug in the 5V power supply.
4. Make sure the PC has a IP address on the 192.168.0.xxx subnet, such as 192.168.0.100.
5. Open your web browser and navigate to 192.168.0.10.
6. Type “admin” for the login field and “password” for the password.
7. The default out-of-box operating mode is Access Point (AP) mode. To switch to Repeater,
P2P, PMP or Client mode, go to the Mode page and select the desired mode. Click Apply. The
board will reboot into the desired mode.
8. After the board reboots, go to the Mode page and click Setup. Configure the applicable
properties for that mode, such as security, SSID, channel, etc.
9. The 5-in-1 should now be ready to use.