User's Manual

Table Of Contents

Pin28

P0.26

Digital I/O

Pin29 P0.25 Digital I/O

Pin30

P0.24

Digital I/O

Pin31

P0.23

Digital I/O

Pin32 P0.22 Digital I/O

Pin33 P0.21 Digital I/O

Pin34 VCC Power Supply

Pin35 NC

Pin36 GND Ground

Block diagram:

General Purpose I/O:

The general purpose I/O is organized as one port enabling access and control of the 32 available

GPIO pins through one port. Each GPIO can be accessed individually with the following user

configurable features:

 Input/output direction

 Output drive strength

 Internal pull-up and pull-down resistors

 Wake-up from high or low level triggers on all pins

 Trigger interrupt on all pins

 All pins can be used by the PPI task/event system; the maximum number of pins that can be

interfaced through the PPI at the same time is limited by the number of GPIOTE channels

 All pins can be individually configured to carry serial interface or quadrature demodulator

signals