User's Manual

10 VCC —
Power Supply’
Positive（3 ~ 3.6V）
11 CFG_MODE I
Select Parameter configuration mode, interval pull up
0：Simple mode：
Input level to set Baud Rate through BAUD_0、BAUD_
Input level to set Connection Interval through CNITV_0、CNITV_1
1：AT command mode：
Sending AT command through UART to set Baud Rate and
Connection Interval 。
12 BAUD_0 I
13 BAUD_1 I
Set Baud Rate（Under Simple Mode），Internal Pull down：
BAUD_0, BAUD_1：
00: 9600
01: 19200
10: 38400
11: 115200
14 CNITV_0 I
15 CNITV_1 I
Set Connection Interval（Under Simple Mode），Internal Pull down：
CNITV_0, CNITV_1：
00: 20ms
01: 100ms
10: 500ms
11: 1000ms
Pls note that ;
1. This User Manual is a guide for OEM /Integrators , is Limited for OEM/Integrator installations
Only.
2. The OEM integrator is responsible for ensuring that the end-user has no manual instruction
to remove or install module
3. Separate approval is required for all other operating configurations, including portable
configurations with respect to Part 2.1093 and different antenna configurations
4. The authorized antennas per Part 15.204 (including antenna specification).
Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
Please notice that if the FCC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a
label referring to the enclosed module. This exterior label can use wording such as the following:
“
Contains FCC ID:
2AA72
-
PTR5518
”
7
COPYRIGHT ©2013 ALL RIGHTS RESERVED LANKE XUNTONG TECHNOLOGY CO.,LTD
TEL: [phone] [phone] E-mail: [e-mail]