Printer User Manual
Table Of Contents
- AP2610 Printer Reference
- Trademarks
- Manuals for This Printer
- How to Read This Manual
- TABLE OF CONTENTS
- 1. Setting Up the Printer Driver and Canceling a Print Job
- PCL 6/5e - Accessing the Printer Properties
- RPCS - Accessing the Printer Properties
- PostScript - Setting Up for Printing
- Canceling a Print Job
- 2. Uninstalling the Printer Driver and Software
- 3. Paper and Other Media
- 4. Sample Print/Locked Print
- 5. Troubleshooting
- 6. Making Printer Settings with the Control Panel
- 7. Appendix
- INDEX
Cleaning and Adjusting the Printer
93
5
Cleaning and Adjusting the Printer
Cleaning the Friction Pad
If the friction pad is dirty, a multi-
feed or a misfeed might occur. In this
case, clean the pad as follows:
A
AA
A
Lift the paper tray slightly then
pull it out until it stops, and while
lifting the front side of the tray,
pull it out of the printer.
B
BB
B
Place the tray on a flat surface.
When there is paper in the tray,
remove paper.
C
CC
C
Wipe the brown part of the fric-
tion pad with a soft damp cloth.
After that, wipe it with a dry cloth
to remove the water.
Important
❒ Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
D
DD
D
Load paper into the paper tray
with the print side up. Carefully
slide the paper tray into the print-
er until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
Note
❒ If misfeeds or multi-feeds of pa-
per occur after cleaning the fric-
tion pad, contact your sales or
service representative.
❒ Follow the same procedure to
clean the friction pad of the op-
tional Paper Feed Unit and the
Envelope Feeder Unit.
ZCEY140J
TS3Y250E
ZCEY150J