Digital Copier Operator Manual

Copy Paper
19
1
*2
If you wish to copy onto non-standard size paper, select the size with User Tools. See
“Tray Paper Settings” in the System Settings manual.
*3
If you wish to copy onto OHP transparencies or thick paper, select OHP or Thick Pa-
per mode. See “Tray Paper Settings” in the System Settings manual.
*4
When setting copy paper, make sure the stack height does not exceed the limit mark.
The maximum number of sheets you can set at once depends on the paper thickness
and condition.
Important
❒
If you use damp or curled paper, a misfeed, staple jam or mis-stapling might
occur. Try turning over the paper stack in the paper tray. If there is no im-
provement, change to copy paper with less curl.
❒
If you use damp or curled OHP transparencies, a misfeed might occur.
❒
When you set the Index tabs, use the end fence for Index tabs.
Note
❒
If you load paper of the same size in two or more trays, the machine automat-
ically shifts to another tray when the tray in use runs out of paper. This func-
tion is called Auto Tray Switching. This saves interrupting a copy run to
replenish paper even when you make a large number of copies. You can turn
off this function. See
⇒
P.37
“Selecting Copy Paper”
, “Auto Tray Switching”
and “Tray Paper Settings” in the System Settings manual.
❒
When you want to copy on translucent paper, set the copy paper following
illustrations. If do not, paper jam might occur.
1. Direction of paper grain
2. How to set the copy paper in the
paper tray
Limitation
❒
If you load recycled or special paper in the paper trays and use the Tray Paper
Settings in User Tools of the System Settings menu, this function is not avail-
able with these trays unless their settings are identical.