Use Instructions

FCC Statement
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum
distance 10mm between the radiator & your body.
CE Statement
Herby,Jiangxi Hongyaoda Communication Co., Ltd.declares
that this Handheld Translation And Recording
Device，Summit is in compliance with the essential
requirements and other relevant provisions of Directive
2014/53/EU.
In accordance with Article 10(2) and Article 10(10), this
product allowed to be used in all EU member states. Use
the Handheld Translation And Recording Device in the
environment with the temperature between -5℃ and 40℃
Use careful with the earphone maybe possible excessive
sound pressure from earphones and headphones can cause
hearing loss.
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the
instructions.
The product shall only be connected to a USB interface of
version USB2.0
SAR: The device complies with RF specifications when the
device used at 5mm from your body.
Operation Frequency:
For 2.4G WIFI:
2412MHz~2472MHz (802.11b/802.11g/802.11n(HT20))
2422MHz~2462MHz (802.11n(HT40))
For BT/BLE:
2402MHz~2480MHz
For GPS: 1.57542GHz
For GSM:
E-GSM 900/GPRS 900/EGPRS 900:
TX: 880-915MHz; RX: 925-960 MHz
E-GSM 1800/GPRS 1800/EGPRS 1800:
TX: 1710-1785 MHz; RX: 1805-1880 MHz
For WCDMA:
UTRA Band I: TX:1920MHz~1980MHz;
RX: 2110-2170MHz
UTRA Band VIII: TX: 880MHz~915MHz;
RX: 925-960MHz
LTE Band 1: (UL)1920MHz~1980MHz,
(DL)2110MHz~2170MHz
LTE Band 3: (UL)1710MHz~1785MHz,
(DL)1805MHz~1880MHz
LTE Band 7: (UL)2500MHz~2570MHz,
(DL)2620MHz~2690MHz
LTE Band 8: (UL)880MHz~915MHz,
(DL)925MHz~960MHz
LTE Band 20: (UL)832MHz~862MHz,
(DL)791MHz~821MHz
LTE Band 28: (UL)703MHz~733MHz,
(DL)758MHz~788MHz
LTE Band 38: (UL)2570MHz~2620MHz,
(DL)2570MHz~2620MHz
LTE Band 40: (UL)2300MHz~2400MHz,
(DL)2300MHz~2400MHz
Max output power:
BT: 0.0011W BLE: 0.0011W WIFI: 0.0212W
E-GSM 900/GPRS 900/EGPRS 900: 1.9953W
E-GSM 1800/GPRS 1800/EGPRS 1800: 0.955W
UTRA Band I: 0.1945W
UTRA Band VIII: 0.1622W
LTE Band 1: 0.2333W
LTE Band 3: 0.2218W
LTE Band 7: 0.1977W
LTE Band 8: 0.246W
LTE Band 20: 0.2193W
LTE Band 28: 0.2089W
LTE Band 38: 0.2089W
LTE Band 40: 0.2138W
Manufacturer：Jiangxi Hongyaoda Communication Co., Ltd.
Address：No.69, North Huangjin Avenue, Ganzhou Economic
and Technological Development Zone, Ganzhou City, Jiangxi
Province,China
Tel: [phone]-8021
Fax: N/A
E-mail: [e-mail]