Assembly Instructions Caution : You must read this before you proceed BAR TABLE Part List Label Picture Description QTY A Table Top 1 B Table Leg 4 C Cross Bar 2 Page 1 of 6
Hardware Label Picture Description QTY ① JCBB M8 x 80mm + S/W 5/16" + F/W 5/16" x 22mm 8 ② Allen Key M5 1 ③ JCBC W M7 x 35mm 1 ④ Allen Key M4 1 ⑤ CSK SCREW M4 x 38mm 4 Assembly Preparation Before Beginning Assembly: Page 2 of 6
Assembly Steps Overview This Bar Table has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Bar Table parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Crossover the Cross Bar (C) as shown. Fix the Cross Bar with JCBC Bolt W ③ using Allen Key ④. DO NOT FULLY TIGHTEN THE BOLT.
Step 2 Place the Table top (A) on a soft surface to avoid any scratches or damages to the product and place the Table Leg (B) onto the of table top corner block with your adult partner. Fix the Table Top (A) with JCBB Bolt ① + Spring Washer + Flat Washer using Allen Key ②. Repeat the step for another leg. DO NOT FULLY TIGHTEN THE BOLT. Step 3 (3.1)With assistance from your adult partner, Slot in the Cross Bar (C) into the mounting position of Table Leg (B) as shown. (3.
Step 4 4.2 4.1 4.1 Repeat step 2, Fix the Table Leg (B) with JCBB Bolt ① + Spring Washer + Flat Washer using Allen Key ②. 4.2 Fix the Cross Bar (C) with CSK Screw ⑤ using Screwdriver (not provided). In case the table wobbles, need loosen tighten the screw and bolts, and use your hand press the top of the table, to make sure the table eveness, and then full tighten the bolts sequence. FULLY TIGHTEN THE BOLT. With assistance from your adult partner, stand the Table up. Your Table is now ready for use.
Care & Maintenance Page 6 of 6
