Assembly Instructions Caution : You must read this before you proceed DINING CHAIR Part List Label Picture Description QTY A Front Leg (A) 1 B Front Leg (B) 1 C Back Leg (C) 1 D Back Leg (D) 1 E Cushion Chair Seat 1 Page 1 of 6
Hardware Label Picture Description QTY ① JCBC M6 x 60mm + S/W M6 + F/W 5/16" x 22mm 8 ② Allen Key M4 1 Assembly Preparation Before Beginning Assembly: Page 2 of 6
Assembly Steps Overview Cushion Seat (E) Back Leg (C) Back Leg (D) Front Leg (B) Front Leg (A) This Dining Chair has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Place the Cushion Chair Seat(E) on the clean Table Top and place the Back Leg (C) Back Leg (D) on the corner block as shown. Then, fix the Back Leg (C) and (D) with JCBC Bolt ① using Allen Key ②. DO NOT FULLY TIGHTEN THE BOLT. Step 2 Repeat Step 1, place the Front Leg (A) and Front Leg (B) on the corner block as shown. Then, fix the Front Leg (C) and (D) with JCBC Bolt ① using Allen Key ②. DO NOT FULLY TIGHTEN THE BOLT.
Place the dining chair on a Level Surface to check if it wobbles. If it wobbles, lift the dining chair some 30cm to 50cm high from the ground, keep your feet and toes well away from the drop zone, and drop the dining chair freely and vertically with the four legs, hitting the ground at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment. Test again for evenness on Level Surface. If no wobbles are found, proceed to tighten all the Bolts.
Care & Maintenance Page 6 of 6
