User Manual

10
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for
turning on and off your equipment. With all system parts connected, turn on source equipment,
MP3/CD players, etc. BEFORE turning on your guitar amplifier. Similarly when turning off your
system always turn down the Volume controls on your guitar amplifier and then turn off its power
before turning off other equipment.
Cables: Only use a good quality screened cable to connect your instrument to the amplifier.
Servicing: The user should not attempt to service these products. Refer all servicing to qualified
service personnel.
---------------------------------------------------------------------------------
This product conforms to the requirements of the following European Regulations, Directives
& Rules:
CE Mark (93/68/EEC), Low Voltage 2006/95/EC, EMC (2004/108/EEC), RoHS
(EU2002/95/EC), WEEE (EU2002/96/EC)
---------------------------------------------------------------------------------
In order to reduce environmental damage, at the end of its useful life, this product must not be
disposed of along with normal household waste to landfill sites. It must be taken to an
approved recycling centre according to the recommendations of the WEEE (Waste Electrical
and Electronic Equipment) directive applicable in your country.
---------------------------------------------------------------------------------
In the interest of continued development, Laney reserves the right to amend product specification
without prior notification.
General Notes