User's Manual

Page 11/24

will result in masmatched impedance and will reduce the amplifiers performance and in some cases may cause damage to the

amplifier. You may connect 1*4ohm, 1*8ohm, 2*8ohm, 2*16ohm cabinets to these sockets. Do not use at the same time as the

16 ohm socket.

16 OHM SOCKET: Use to connect a single 16 ohm cabinet. Do not use at the same time as the 4-8 ohm sockets.

LOUDSPEAKER EXAMPLES:

RECORD OUT: Use to connect to your chosen recording device. This socket will emulate the sound of the output tube

stage so you don’t lose that fantastic sound. Used in combination with the mute switch will enable silent recording.

EFFECTS RETURN:

Note: TT100H rear shown on page 10. TT50H rear features identical other than print details.

Connect the output from your external effects to this socket. Use only good quality shielded cables.

EFFECTS SEND: Connect the input of your external effects unit to this socket. Some Effects are better suited to being

between the guitar and amplifer input - these are foot pedal types / distortion / wah wah pedals etc. Rack mount effects will

work better in the FX loop on the amplifer rear. Stomp boxes are normally designed for small signals such as a guitar output

whereas rack mount FX are designed for the higher signal level obtained from an FX send. Use only good quality shielded

cables.

FOOTSWITCH: This is a 15 pin dtype socket for connection of the dedicated Laney FS6 footswitch enclosed with the

amplifier. The FS6 allows remote switching of Channel 1, Channel 2, Channel 3, Volume 1&2 and Reverb. Do not connect any

other device to this socket.

MIDI: See midi section on page 12.

REAR PANEL CONTROLS - CONTINUED

Laney

OPERATING INSTRUCTIONS

4 ohm

8 ohm 16 ohm

8 ohm 8 ohm 16 ohm

16 ohm

0H/

TT1 H

5 00