User's Manual

USER SETTINGS
Page 10 /12
Found some cool settings you want to keep? Make a note of them here:
General Notes
Amplifier connection: In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, turn on source equipment, tape decks, cd players, mixers, effects processors etc.
BEFORE turning on your Bass Amplifier. Many products have large transient surges at turn on and off which can cause damage to
your speakers. By turning on your Bass Amplifier LAST and making sure its Volume control is set to minimum any transients from
other equipment will not reach your loudspeakers. Wait until all system parts have stabilised; usually a couple of seconds. Similarly
when turning off your system always turn down the Volume control on your Bass Amplifier and then turn off its power before
turning off other equipment.
Cables: Never use shielded or microphone cable for any speaker connections as this will not be substantial enough to handle the
amplifier load and could cause damage to your amplifier system.
Caution: These professional loudspeaker systems are capable of generating very high sound pressure levels. Use care with
placement and operation to avoid exposure to excessive levels that can cause permanent hearing damage. (Refer to guidelines on
page 2)
Servicing: The user should not attempt to service these products. Refer all servicing to qualified service personnel.
Laney
OPERATING INSTRUCTIONS
SPECIFICATIONS
Supply Voltage ~100V, ~120V, ~220V, ~230V, ~240V 50/60Hz Factory Option
Mains Fuse ~220V>~240V = T3.15A L. ~100>120V = T6.3A L (Time delay)
Power Consumption 450W
Output Power Rating 300W
Loudspeaker Two 10” Custom Designed Drivers + high frequency horn
Features Normal + Hi Inputs
Switchable Compressor with status lights
Switchable Limiter with status light
Switchable high frequency horn
Kickback style cabinet
Enhance
EQ Bass ( Shelving)
Treble ( Shelving)
Lo Paramid ( 1KHz Peaking)
Hi Paramid
D.I. Yes, Balanced XLR
Tuner Out Yes
Extension Loudspeaker Socket Yes (8 Ohms minimum)
FX Loop Yes (0dBu Nominal) (Series-Insert)
Input Impedance 1M Ohm/100pF
Recommended Min Extension Speaker Power 150W
Recommended Richter Extension Cab RB410 / RB115
Size 458*582*397 (H*W*D)
Unit Weight 25 Kg
Packing Weight 27.5 Kg
±12dB at 40Hz,
±15dB at 3.5KHz,
±12dB at 100Hz >
(±12dB at 400Hz > 4KHz Peaking)
This product conforms to:
European EMC directive(2004/108/EC), Low Voltage Directive (72/23/EEC) and CE mark Directive (93/68/EEC)
Page 11 /12
Laney
OPERATING INSTRUCTIONS