User Manual

987rev701
8J306Page 10
5. Install belts and tighten. See figures an~ instructions on proper belt tension and alignment on
page
7. Tighten belts by loosening mounting bolts on gearbox base and upper pulley bearings,
then tum adjusting screws. Move both gearbox and shaft bearings equally to maintain alignment
betw~en pulleys and gearbox.
To check alignment of pulleys and gearbox visually, sight along drive shaft shields using front of
machine as a reference line.
6. Attach front hitch, with slotted clevis plate down, to front of frame with 1" diameter clevis pins.
Then attach two drawbar links to the lower holes on both front hitch and shredder frame, using the
remaining clevis pins. Do not operate the machine unless the drawbar links are installed.
(f) '
SLOTTED CLEVIS PLATE
........
7. Attach the implement end of the telescoping drive line to the gearbox, insert bolt and tighten
lOcknut. Lubricate the telescoping section of the drive line by compressing completely to expose
· · the · 1ube fitting through the holes In the shield.
GEARBOX
/ CAPSCREW,
5116" x 3"
/LUBE FITTING
DRIVE LINE