User Manual

Chapter 4 - Extender Configuration in Command Center Landis+Gyr
34 98-1178 Rev AA Installation and User Guide
Figure 4 - 6. Time Zone List
3. Note the correct Time Zone Value for your IIF.
Extender Management
The RF Mesh Endpoint Information screen will also provide information about the Extenders and
Mesh Extenders in the utility’s RF Mesh system. This screen summarizes information about a
selected Extender and provides an interface for sending commands to the Extender.
Following is the procedure to view Gridstream RF Endpoint Information for a Extender from main
Command Center screen:
1. From Command Center home, select Operations > Endpoints. The Endpoint/Meter Selection
window will open.
Figure 4 - 7. Endpoint/Meter Selection
2. Enter the Extender Serial Number or Meter Number
3. Click Go. The Endpoint/Meter Selection screen will refresh and display tasks available for the
Extender.
DRAFT 5.14.2012