User Manual

Landis+Gyr Chapter 4 - Extender Configuration in Command Center
Installation and User Guide 98-1178 Rev AA 33
4. Click Save to upload the file.
5. The Extender described in the IIF should now appear in Command Center. The Extender should
display the data entered for it and have the status 'Installed'.
Time Zone
In order to report readings time correctly, the Extender must be programmed with the appropriate
time zone. This is achieved by sending commands to the Extender that indicates the time zone in
which the endpoint is installed and whether Daylight Savings Time (DST) is observed in the given
time zone.
The meter installer should include the endpoint time zone in the Installation File. To make it easy for
installers to specify a time zone, the Time Zone List link will open a document that displays a list of
valid time zone designations by country.
1. From Command Center home, select Operations > Import > Import Installation File.
The Import Installation File window will open.
Figure 4 - 5. Import Installation File Window
2. Click on the Time Zone List Link. The TimeZonesForInstallation window will open.
DRAFT 5.14.2012