User Manual

Chapter 2 - Installation Landis+Gyr
14 98-1178 Rev AA Installation and User Guide
Grounding (Optional)
If a ground wire is required for your installation, a 6 AWG solid copper wire is recommended.
1. Install a 6 AWG solid copper wire ground connector (A) by tightening the screw (B).
2. Insert the grounding wire (C) through the ground connector and into the small hole in the
enclosure (D).
3. Insert and tighten the screw (E) to fix the wire as shown.
4. Tighten the set screw (F) on the ground connector.
Figure 2 - 4. Install Ground Connector
Wood Pole Mount Installation
Required Tools
• Installation sheet
• Extender & applicable installation kit
• Extender power cable
• Extender antenna
• Optinal 6 AWG solid copper ground wire
• Personal protection equipment
• Power disconnect box
• Power drill with level, 3/4 inch augur bit
• Adjustable-end wrenches
• Standard socket wrench set
• Wire strippers
• Screwdrivers
A
B
C
D
E
F
DRAFT 5.14.2012