Data Sheet

Data Sheet 98-2947 Rev AA | 7
Series 6 MCM0 Data Sheet
Figure 5. PCB Stack Up
Information on Test Modes and Additional Testing Requirements
A diagnostic test mode is available to device integrators that allows control of the
transmitter in order to execute FCC 15.247 compliance testing. This mode of operation
provides a basic command interface over a dedicated serial port. Further information on
how to enable this mode of operation and a description of the command interface is
available to device integrators upon request and under NDA.
Additional Testing, Part 15 Subpart B Disclaimer
The end product with an embedded S6 MCM0 may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15
Subpart B.
Host Label Requirement
In the final installation, the following information must be visible:
• Contains FCC ID: R7PNG0R1X8
• Contains IC: 5294A-NG0R1X8
Sample label shown below:
Figure 6. Example Host Label
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
Draft 07.11.2022 A