Data Sheet

6 | 98-2947 Rev AA Data Sheet
Series 6 MCM0 Data Sheet
and used in accordance with the Instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult Landis+Gyr or an experienced radio technician for help.
 WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr
could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20
cm between the radiator and your body. The antenna(s) used for this transmitter must not
transmit simultaneously with any other antenna or transmitter, except in accordance with
FCC multi-transmitter product procedures.
Cet équipement est conforme aux limites FCC/ISED d'exposition aux radiations définies
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à une
distance minimale de20cm entre le radia-teur et votre corps. Cet émetteur ne doit pas être
co-implantés ou exploités en conjonction avec une autre antenne ou émetteur.
Requirement for Modular Certification
The Series 6 MCM0 is approved for use with the antenna listed below. Antenna types not
included in the list below or a having higher gain than the maximum indicated for that type,
are prohibited for use with this device.
Approved Antennas
The antenna listed in the following table is approved for use with the device:
Figure 4. P rinted Inverted F Antenna and CPW Transmission Line
Frequency Antenna Type Max Gain (dBi) Referenced Product
902-928 MHz PCB Printed Inverted F Antenna 1.0 E360
CPW
Draft 07.11.2022 A