Data Sheet

6 | 98-1837 Rev AI Data Sheet
Network Node Data Sheet
FCC, Industry Canada Compliance, and Regulatory Compliance
Brazil
FCC Class B
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference, and
• This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the Instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult Landis+Gyr or an experienced radio technician for help.
 WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr
could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC and ISED Canada radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated with
minimum distance 27 cm between the radiator and your body. This transmitter must not be
co-located or operated in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites FCC/ISED Canada d’exposition aux radiations
définies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé à une distance minimale de 27 cm entre le
radiateur et votre corps.
Cet émetteur ne doit pas être co-implantés ou exploités en conjonction avec une autre
antenne ou émetteur.
Industry Canada
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that necessary for successful communication.