User Manual
Table Of Contents
- Chapter 1: Product Overview 1
- Chapter 2: Configuration & Testing 19
- Chapter 3: Development Environment 27
- Product Overview
- Introduction
- Performance Specifications
- Electrical Interface
- Pin Functions
- Pin 1 (VIN)
- Pin 2 (LPP TX) and Pin 3 (LPP RX)
- Pin 4 (DIGITAL_IO1) and Pin 11 (DIGITAL_IO2)
- Pin 5 (ANALOG_IN1) and Pin 10 (ANALOG_IN2)
- Pins 6 and 7 (GND)
- Pin 8 (LOW_RF_POWER)
- Pin 9 (PWR_DN)
- Pin 12 (TPP RX) and Pin 13 (TPP TX)
- Pin 14 (3.3V_Logic_supply)
- USB Programming Cable
- USB Cable Installation
- Antennas
- External Antenna
- On-board Antenna
- Additional Specifications
- Dimensions: Gridstream S4SBR 25-1681 / 25-1682
- Dimensions: Gridstream S4SBR 25-1683 / 25-1684
- Configuration & Testing
- Development Environment
- Gridstream SCADA/DA Series 4 Single Board Radio Interface Board
- Transparent Port (TPP) Connection
- LAN Packet Port (LPP) Connection
- Onboard Regulator
- Digital Input
- Analog Input
- General Usage Instruction
- Gridstream S4SBR Logic
- Control Register 1
- Control Register 2
- Digital I/O Functionality
- Analog Input Functionality
- Memory Location
- Manufacturer Contact Information
- External Antenna Specifications
- Ground Plane Specifications
- RF External Antenna Cable Specifications
- External Antenna Radiation Pattern
- Identifying a Reverse-Polarity Connector
- Specifications
- On-board Antenna Radiation Pattern
- FCC Class B
- RF Exposure
- Industry Canada
- Host FCC Label Requirement
- Data Sheets
- Whip Antenna P/N 16-1000-0
- RF External Antenna Cable P/N 21-1000-0
C
Gridstream SCADA/DA S4SBR 98-1138 Rev AD 41
FCC and Industry Canada
Compliance
FCC Class B
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the Instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult Landis+Gyr or an experienced radio technician for help.
U WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr
could void the user's authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 20
centimeters between the radiator and your body. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
draft 29 Jan 2013