User Manual
Table Of Contents
- Chapter 1: Product Overview 1
- Chapter 2: Configuration & Testing 19
- Chapter 3: Development Environment 27
- Product Overview
- Introduction
- Performance Specifications
- Electrical Interface
- Pin Functions
- Pin 1 (VIN)
- Pin 2 (LPP TX) and Pin 3 (LPP RX)
- Pin 4 (DIGITAL_IO1) and Pin 11 (DIGITAL_IO2)
- Pin 5 (ANALOG_IN1) and Pin 10 (ANALOG_IN2)
- Pins 6 and 7 (GND)
- Pin 8 (LOW_RF_POWER)
- Pin 9 (PWR_DN)
- Pin 12 (TPP RX) and Pin 13 (TPP TX)
- Pin 14 (3.3V_Logic_supply)
- USB Programming Cable
- USB Cable Installation
- Antennas
- External Antenna
- On-board Antenna
- Additional Specifications
- Dimensions: Gridstream S4SBR 25-1681 / 25-1682
- Dimensions: Gridstream S4SBR 25-1683 / 25-1684
- Configuration & Testing
- Development Environment
- Gridstream SCADA/DA Series 4 Single Board Radio Interface Board
- Transparent Port (TPP) Connection
- LAN Packet Port (LPP) Connection
- Onboard Regulator
- Digital Input
- Analog Input
- General Usage Instruction
- Gridstream S4SBR Logic
- Control Register 1
- Control Register 2
- Digital I/O Functionality
- Analog Input Functionality
- Memory Location
- Manufacturer Contact Information
- External Antenna Specifications
- Ground Plane Specifications
- RF External Antenna Cable Specifications
- External Antenna Radiation Pattern
- Identifying a Reverse-Polarity Connector
- Specifications
- On-board Antenna Radiation Pattern
- FCC Class B
- RF Exposure
- Industry Canada
- Host FCC Label Requirement
- Data Sheets
- Whip Antenna P/N 16-1000-0
- RF External Antenna Cable P/N 21-1000-0
Chapter 3 - Development Environment Landis+Gyr
28 98-1138 Rev AD Gridstream SCADA/DA S4SBR
Figure 3 - 2. Board Components Schematic
NOTE: With the digital input switch tying the digital I/O pin on the Gridstream S4SBR to either a
logic 0 or a logic 1 voltage level, this Development Test Platform One does not have functions to
test the digital output of the Gridstream S4SBR. It is recommended to NOT configure the digital I/O
pin as output when the Gridstream S4SBR is connected to the test interface board.
Transparent Port (TPP) Connection
This connector is used to establish connection to the Gridstream S4SBR through the transparent port.
When communication through the transparent port is desired, connect the USB cable to this
connector.
LAN Packet Port (LPP) Connection
This connector is used to establish connection to the Gridstream S4SBR through the LAN packet
port. When communication through the LAN packet port (using RadioShop) is desired, connect the
USB cable to this connector.
Onboard Regulator
The Gridstream S4SBR interface board is equipped with an onboard VDC regulator. This regulator
accepts a 4.0 ~ 7.0 VDC input from a main power source and regulates it to power device
electronics.
draft 29 Jan 2013