User Manual
Table Of Contents
- Chapter 1: Product Overview 1
- Chapter 2: Configuration & Testing 19
- Chapter 3: Development Environment 27
- Product Overview
- Introduction
- Performance Specifications
- Electrical Interface
- Pin Functions
- Pin 1 (VIN)
- Pin 2 (LPP TX) and Pin 3 (LPP RX)
- Pin 4 (DIGITAL_IO1) and Pin 11 (DIGITAL_IO2)
- Pin 5 (ANALOG_IN1) and Pin 10 (ANALOG_IN2)
- Pins 6 and 7 (GND)
- Pin 8 (LOW_RF_POWER)
- Pin 9 (PWR_DN)
- Pin 12 (TPP RX) and Pin 13 (TPP TX)
- Pin 14 (3.3V_Logic_supply)
- USB Programming Cable
- USB Cable Installation
- Antennas
- External Antenna
- On-board Antenna
- Additional Specifications
- Dimensions: Gridstream S4SBR 25-1681 / 25-1682
- Dimensions: Gridstream S4SBR 25-1683 / 25-1684
- Configuration & Testing
- Development Environment
- Gridstream SCADA/DA Series 4 Single Board Radio Interface Board
- Transparent Port (TPP) Connection
- LAN Packet Port (LPP) Connection
- Onboard Regulator
- Digital Input
- Analog Input
- General Usage Instruction
- Gridstream S4SBR Logic
- Control Register 1
- Control Register 2
- Digital I/O Functionality
- Analog Input Functionality
- Memory Location
- Manufacturer Contact Information
- External Antenna Specifications
- Ground Plane Specifications
- RF External Antenna Cable Specifications
- External Antenna Radiation Pattern
- Identifying a Reverse-Polarity Connector
- Specifications
- On-board Antenna Radiation Pattern
- FCC Class B
- RF Exposure
- Industry Canada
- Host FCC Label Requirement
- Data Sheets
- Whip Antenna P/N 16-1000-0
- RF External Antenna Cable P/N 21-1000-0
3
Gridstream SCADA/DA S4SBR 98-1138 Rev AD 27
Development Environment
Gridstream SCADA/DA Series 4 Single Board Radio
Interface Board
This section provides instruction for the using the Gridstream S4SBR interface. A simple prototype
board block diagram is provided to demonstrate how to connect a Gridstream S4SBR to a PC-
compatible computer either for programming or to integrate the Gridstream S4SBR into OEM
devices.
NOTE: The drawings provided in this section are for design reference purposes only. No interface
board is available for purchase from Landis+Gyr.
Figure 3 - 1. Board Component Layout with On-board Antenna
draft 29 Jan 2013