User Manual
Table Of Contents
- Chapter 1: Product Overview 1
- Chapter 2: Configuration & Testing 19
- Chapter 3: Development Environment 27
- Product Overview
- Introduction
- Performance Specifications
- Electrical Interface
- Pin Functions
- Pin 1 (VIN)
- Pin 2 (LPP TX) and Pin 3 (LPP RX)
- Pin 4 (DIGITAL_IO1) and Pin 11 (DIGITAL_IO2)
- Pin 5 (ANALOG_IN1) and Pin 10 (ANALOG_IN2)
- Pins 6 and 7 (GND)
- Pin 8 (LOW_RF_POWER)
- Pin 9 (PWR_DN)
- Pin 12 (TPP RX) and Pin 13 (TPP TX)
- Pin 14 (3.3V_Logic_supply)
- USB Programming Cable
- USB Cable Installation
- Antennas
- External Antenna
- On-board Antenna
- Additional Specifications
- Dimensions: Gridstream S4SBR 25-1681 / 25-1682
- Dimensions: Gridstream S4SBR 25-1683 / 25-1684
- Configuration & Testing
- Development Environment
- Gridstream SCADA/DA Series 4 Single Board Radio Interface Board
- Transparent Port (TPP) Connection
- LAN Packet Port (LPP) Connection
- Onboard Regulator
- Digital Input
- Analog Input
- General Usage Instruction
- Gridstream S4SBR Logic
- Control Register 1
- Control Register 2
- Digital I/O Functionality
- Analog Input Functionality
- Memory Location
- Manufacturer Contact Information
- External Antenna Specifications
- Ground Plane Specifications
- RF External Antenna Cable Specifications
- External Antenna Radiation Pattern
- Identifying a Reverse-Polarity Connector
- Specifications
- On-board Antenna Radiation Pattern
- FCC Class B
- RF Exposure
- Industry Canada
- Host FCC Label Requirement
- Data Sheets
- Whip Antenna P/N 16-1000-0
- RF External Antenna Cable P/N 21-1000-0
Landis+Gyr Chapter 2 - Configuration & Testing
Gridstream SCADA/DA S4SBR 98-1138 Rev AD 25
Figure 2 - 9. Configuring the WAN Address
A message will appear indicating that the radio was successfully programmed.
Troubleshooting
The Gridstream S4SBR has been designed as a Field Replaceable Unit (FRU). As such, there are no
serviceable parts in the unit.
If you suspect parts within the Gridstream S4SBR have failed:
1. Inspect the module to determine if there is any visual indication of damage to the unit.
2. Verify that power is being supplied to the unit. If the power is within operating parameters,
proceed to Step 3.
3. Try to connect with a locally connected Series-4 IWR configured the same as the Gridstream
S4SBR. If, after five minutes, the locally connected Series-4 IWR does not acquire the
Gridstream S4SBR in its neighbors list, the Gridstream S4SBR should be replaced.
For additional assistance for this product, contact Landis+Gyr Technical Support at 1-888-390-5733
or
solutionsupport.na@landisgyr.com.
draft 29 Jan 2013