User Manual
Table Of Contents
- Chapter 1: Product Overview 1
- Chapter 2: Configuration & Testing 19
- Chapter 3: Development Environment 27
- Product Overview
- Introduction
- Performance Specifications
- Electrical Interface
- Pin Functions
- Pin 1 (VIN)
- Pin 2 (LPP TX) and Pin 3 (LPP RX)
- Pin 4 (DIGITAL_IO1) and Pin 11 (DIGITAL_IO2)
- Pin 5 (ANALOG_IN1) and Pin 10 (ANALOG_IN2)
- Pins 6 and 7 (GND)
- Pin 8 (LOW_RF_POWER)
- Pin 9 (PWR_DN)
- Pin 12 (TPP RX) and Pin 13 (TPP TX)
- Pin 14 (3.3V_Logic_supply)
- USB Programming Cable
- USB Cable Installation
- Antennas
- External Antenna
- On-board Antenna
- Additional Specifications
- Dimensions: Gridstream S4SBR 25-1681 / 25-1682
- Dimensions: Gridstream S4SBR 25-1683 / 25-1684
- Configuration & Testing
- Development Environment
- Gridstream SCADA/DA Series 4 Single Board Radio Interface Board
- Transparent Port (TPP) Connection
- LAN Packet Port (LPP) Connection
- Onboard Regulator
- Digital Input
- Analog Input
- General Usage Instruction
- Gridstream S4SBR Logic
- Control Register 1
- Control Register 2
- Digital I/O Functionality
- Analog Input Functionality
- Memory Location
- Manufacturer Contact Information
- External Antenna Specifications
- Ground Plane Specifications
- RF External Antenna Cable Specifications
- External Antenna Radiation Pattern
- Identifying a Reverse-Polarity Connector
- Specifications
- On-board Antenna Radiation Pattern
- FCC Class B
- RF Exposure
- Industry Canada
- Host FCC Label Requirement
- Data Sheets
- Whip Antenna P/N 16-1000-0
- RF External Antenna Cable P/N 21-1000-0
2
Gridstream SCADA/DA S4SBR 98-1138 Rev AD 19
Configuration & Testing
Overview
In this overview, the Gridstream SCADA Series 4 Single Board Radio (Gridstream S4SBR) is
configured using the RadioShop program. Setup is similar to setting up and configuring any
Gridstream Radio.
Refer to the RadioShop Getting Started Guide, Landis+Gyr publication 98-1008, for further details
about using RadioShop.
NOTE: RadioShop’s version number changes as new features and functionality are added to the
application.
Connecting to a Gridstream S4SBR using RadioShop
Connect the LAN Packet Protocol port of your Gridstream S4SBR to your computer's serial port
using the USB cable. Once the Gridstream S4SBR is powered up, you can launch RadioShop on
your computer. RadioShop will now connect to your local Gridstream S4SBR card.
1. On the RadioShop home screen, click Discover | Force Scan and Discover Entry Ports.
NOTE: When the Select COM Ports for Discovery window opens, select the COM port on your
computer that is connected to the Gridstream S4SBR, and then click OK.
draft 29 Jan 2013