User's Manual

Chapter 2 - Configuration & Testing Landis+Gyr
24 98-1546 Rev AA UtiliNet SCADA Single Board Radio
Figure 2 - 8. RMFM is added to Nodes Pane
5. Highlight the new UtiliNet SBR, Figure 2 - 8, and click Reports > Configuration > Radio to
verify that you can communicate with the UtiliNet SBR
6. On the report, you can verify the firmware version and current network ID.
Setting the Latitude & Longitude
1. From RadioShop home click Configure > Wan Address.
2. The Configure WAN Address window, specify the new coordinates and click OK.
Figure 2 - 9. Configuring the WAN Address
A message will appear indicating that the radio was successfully programmed.