User's Manual

Chapter 2 - Configuration & Testing Landis+Gyr
22 98-1546 Rev AA UtiliNet SCADA Single Board Radio
The Final Confirmation dialog is displayed
Figure 2 - 5. Final Confirmation dialog box
4. Click Next to change the Network ID for the radio.
A confirmation message verifies that the Network ID has been changed.
Assigning a New Network ID to a Radio
To assign a new Network ID to a radio, perform the following steps.
1. Select Configure > Network Id (CRC). The first dialog of the Network ID Wizard is displayed.
2. Select Create a New Network, and then click Next.
The Specify New Network dialog is displayed
Figure 2 - 6. Specify New Network
3. Specify the Network ID and Name of the new network you want to assign, and click Next to
continue.
Radio will reboot.
Important:
Assign a new Network ID only if the ID you want to use does not exist already.
Valid values range from 1 to 65535. If 0 is displayed at startup, call customer support.