User's Manual

Landis+Gyr Chapter 2 - Configuration & Testing
UtiliNet SCADA Single Board Radio 98-1546 Rev AA 21
Assign the Network ID (CRC) of the UtiliNet SBR
All UtiliNet SBRs ship with a default network ID, or CRC, of 670. In order to communicate with
other radios in a customer's network, the UtiliNet SBR will have to be re-configured to match the
customer's unique network ID.
1. From RadioShop home, select Configure>Change Network ID (CRC). The Network ID
Wizard dialog box will open, as shown in Figure 2 - 3
2. Select Use an Existing Network, and click Next to continue.
Figure 2 - 3. Network ID Wizard
The Choose an Existing Network dialog is displayed
Figure 2 - 4. Choose an Existing Network
3. Choose a Network ID from the Available Networks drop-down list, and click Next to continue.
All RF Mesh radios ship with a default network ID, or CRC, of 670. In order to communicate with
the UtiliNet SBR, your local radio will have to be re-configured to match the network ID (670) of the
UtiliNet SBR. After re-configuring the UtiliNet SBR to match the customer’s unique network ID, the
local radio will need to be reset to it’s original network ID. See “Assign the Network ID (CRC) of the
UtiliNet SBR” on page 21 or see “Assigning a New Network ID to a Radio” on page 22., for steps
to re-configure the local radio.
Network ID or CRC are usually assigned for each customer. Please call Customer Service at 888-
390-5733 if you require a Network ID or CRC.