User's Manual

UtiliNet® Endpoint User Guide 11-1-2006
Page 15 of 30
© Cellnet 2005
Setting the Latitude and Longitude
In order to give your device a fixed Latitude and Longitude you must first specify the meter
module as a “non-mobile” device. Do this by selecting Configure>>Send DCW from the main
menu and selecting the UMOBILE.HEX DCW. Once sent confirmation should be displayed on a
“DCW Response” tab as shown below.
Next you will have to set up a Latitude and Longitude or "”WAN Address” for your integrated
meter module. This is the GPS coordinates of the radio. To set the WAN address, go to
Configure>>Wan Address. Specify the new Latitude/Longitude of your integrated meter module
and click OK. A message should appear indicating that the remote radio was successfully
programmed. The color feature may be used if you are planning on installing more than one meter
in the same geographic location.
Updating the Network ID (CRC Adder)
In order to configure your integrated meter module with your company’s unique network ID or
CRC Adder you must first add a network to RadioShop with your company’s network ID. Select
Utilities>>Network>>Add Network from the RadioShop main menu to access the “Add Network”
screen. Name the network and specify the network ID (CRC Adder) to your company’s assigned