Installation Guide

Landis+Gyr Chapter 2 - Installing the Cellnet Water Endpoint
CWE 6060 Remote Installation Guide 98-1552 9
2Usingthe#22AWGholeofthewire‐strippingtool,stripone‐halfinchofinsulationfromeachof
thethreeinternalwires.
Figure 2 - 2. Wire stripper
3 Connectthethree‐conductorwiretotheencoderregisterʹsterminals,matchingcolorscarefully.
Threadthecablearoundthestrainreliefpostsoftheencoderregister. 
Figure 2 - 3. Threading the cable around the strain relief posts
4Applymoistureprotectioncompoundtoterminalscrewsandexposedwires(DowCorning
Compound#4orNovagard
®
G661™)
Figure 2 - 4. Applying moisture compound
5Snapthecoverontotheencoderregister.
6Wipeawayexcesscompound.
7RouteencodercablefromencodertothemountedlocationoftheCWERemote.
8 MounttheCWERemote
9SplicethewiresfromtheCWERemotetothethreewiresfromtheencodercable.
Position the end of the cable jacket so that the compound will cover
it and it will not be visible when the cover is installed, as shown.
Be sure that the waterproofing compound completely seals the wires. Apply compound under
the cable and individual wires. Cover the top of the cable, wires, and screws. Use enough
compound so it flows from openings when the cover is attached.