Installation Guide Part 2

aáÑÑáÅìäíLkçåJÅçãé~íáÄäÉ=`çããÉêÅá~ä= oÉíêçÑáíë
bJQ `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
Reverse Loop Installations
Somemeterswillbeinstalledwiththepipingreversedfromthepreferred
orientation.Inthesecasestheindexisreversedtofacethebackofthemeter.Itis
extremelyimportantinthesecasesthattheBasePlatebemountedsuchthatthe
indexdrivefromthemeterbecenteredintheholeintheBaseplate.SeeFig
u
reE.5
foranexampleoftheinsertbaseplatemountedbackwards.
Figure E.5 Plate Mounted Backwards
IfthisisencountereditcanbecorrectedbyrotatingtheIndexBasePlate180
degrees.
Large Pipe Fittings
FigureE.6showsameterthatdoesnothaveadequateclearancebetweenthePipe
fittingnutsandthemoduletransmitter.Ininstallat ionssuchasthis,themodule
bracketmustberemovedbeforethemetercanberemovedfromservice.
Figure E.6 Pipe Clearance