Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉé F
VJNS `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
3Scan(enter)theModuleIDinLANAddressfield.
Figure 9.10 “Inspect Mode” With Power LAN Scanned In
GPrepcomparestheModuleIDenteredinthisfieldwiththeLANAddress
programmedintothemodule.Ifthepopulatedfieldmatchestheprogrammed
value,amessagedisplays“addressverified”.Iftheenteredvaluedoesnotmatch
theprogrammedvalueadialogboxdisplays,statingthe“LANAddressdoesnot
matchtheprogramm
edva
lue”andinstructstheoperatortoreenterthepower
LANlabelvalue,duetoamisinterpretationormis‐enteredvalue.GPrepinstructs
theoperatortoroutethemoduletoMRBforfurtherdispositioniftheentered
valuesdonotmatchagain.
IfthepowerLANvaluedoesnotmatchthe pr
ogrammedva
lue,arecordisalso
generatedinthe“inspectfile”showingtheinspectionhasfailed.Modulesthatfail
inspectionmustbesegregatedandroutedtoMRB.
If the result of the inspection is verified, a record in the “inspect file” is created showing
that the module Inspection is successful. It also captures the PCB ID of the module in the
same record.