Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉé F
VJQ `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
•Ifthisisanupgrade,thenyoucanusetheexistingGPREP.INIfileto
modifyanyconfigurationparametersasnecessary.
bEdittheGPREP.INIfileusingNotepadoranyotherASCIIfileeditor.
cFollowtheinstructions inthatfiletospecifytherequiredpatternfor
MeterIDs,file(s)forloggingoperations,menuselectionsthatare
available totheoperator
andthemaximummemoryusedtotrack
previouslogfileassociations.
FollowingisanexampleofaGPREP.INIfile.
; The Default section remembers GPrep settings from the last run. These
should
; not be changed manually.
; -------------------------------------------------------------------------
-----
[Default]
; The Control section contains GPrep operational parameters.
; -------------------------------------------------------------------------
-----
; Operator Meter Type selections are controled by variables:
;
; RGAS for ResGas
; CIGD for C&I Gas (Diaphragm)
; CIGR for C&I Gas (Rotary)
; CPRG for CPR Gas (Rotary)
;
; Setting any of these to "No" disables the menu item. The default is
"Yes".
;
; Example:
; RGAS=No
; CIGR=Yes
; Disables "ResGas" selection, leaving both C&I and CPR selections enabled.
; -------------------------------------------------------------------------
-----
; Operator Mode selections are controled by variables:
;
; Inspect
; ProgramNew
; ProgramOld
; IndexRead
; MRBMode
;
; Setting any of these to "No" disables the menu item. The default is
"Yes".
;
; Example:
; ProgramOld=No
; Inspect=Yes
; MRBMode=No
If you run GPrep in different modes and/or it requires different configuration settings at the
same operator station, then install multiple copies of GPrep in different directories.